Atwood and Dometic electronic-ignition water heaters use several distinct 12V control boards. The 91365 is designated for specified combination gas/electric heaters; the 91367 is a gas-only ignition board; and 91363 is the manufacturer's universal service kit for particular legacy systems. The correct board depends on the original model and connector—not just its electrical voltage.

Three main Atwood control arrangements

91365 — gas and electric

91365 and the separate 91365MC support identified combination models including GCH6A-10E and GC6AA-10E. Their connector and original-board cross-reference must match.

91367 — gas only

91367 is a gas-only DSI control. 91367MC is an aftermarket version with its own part matching and connector requirements. Neither should be selected as a blanket substitute for a 91365.

Universal / configurable options

91363 is an OEM universal ignition kit; 91363MC is a separate aftermarket item. Dinosaur UIB 64 offers specific configurable connections but requires the maker's correct jumper setup.

Where the control board operates

12V thermostat and safety inputsSignal the call for heatCorrect model-specific ignition controlRuns approved burner ignition sequenceElectrode and gas-valve circuitOperate when safety conditions are met

This is an original functional component overview, not a wiring diagram. Never bypass thermostats, thermal cut-offs, flame-detection components or other safety devices.

Atwood control board and adapter part numbers

MPN Part type Selection guidance
91363 Dometic universal ignition kit A universal service kit for specifically listed Atwood DSI heaters. Dometic includes an electrode; confirm original board number and heater model.
91363MC M.C. Enterprises ignition board Aftermarket kit identified for selected earlier DSI applications; not interchangeable merely because the original used 12V.
91365 Dometic gas/electric board Two-stage ignition control for specified combo GCH6A-10E, GC6AA-10E, GC10A-4E, GCH10A-4E and XT variants; older slide connector may require 92074.
91365MC M.C. Enterprises combo board Aftermarket gas/electric board with a particular pin connection; confirm corresponding OEM board and heater label.
91367 Dometic gas-only board Factory gas-only ignition board, not the gas/electric 91365 control; early edge connection may need the correct 92075 adapter.
91367MC M.C. Enterprises gas-only board Aftermarket board for selected original gas-only controls; match its own manufacturer cross-reference and harness.
UIB 64 Dinosaur UIB 64 configurable board Configurable 12V board for specified compatible water heater arrangements. Connector and jumper settings require the Dinosaur instructions.
92075 Dometic edge-to-pin adapter Connector adapter documented for particular 91367 control conversions. This is not the 92074 specified for 91365.
92075MC M.C. Enterprises wiring adapter Aftermarket edge-to-pin conversion harness; match the board and original connector before ordering.
Manufacturer distinction: Dometic's replacement-parts chart names 91365 as the potted circuit board for combo gas/electric heaters, 91367 for gas-only heaters, and 91363 as a universal ignition-control kit. This does not make all three interchangeable. Match the appliance model, original number and production version.

Do you need an edge-to-pin connector adapter?

Certain older Atwood water heaters use slide or edge-style harnesses, while later replacement boards have pin-style connectors. For the 91365 combo board, the manufacturer's replacement information identifies the 92074 adapter where the old slide connector requires it. The 92075 Dometic harness is documented for the 91367 board conversion. These are not interchangeable adapters.

Aftermarket 92075MC is also an edge-to-pin harness, but its precise application must match the intended board. Dinosaur UIB 64 offers several supported connector arrangements with jumper-configurable settings; follow the Dinosaur model-specific directions rather than assuming a plug-in replacement.

Check the fault before replacing a control

An RV water heater that does not ignite may have a disconnected 12V feed, poor ground, faulty thermal cutoff, thermostat, spark electrode, burner issue or propane supply problem rather than a failed control board. Verify the actual water heater model and original board, then follow its service diagnostic sequence. Turn off electrical power and propane before service. LP-gas and ignition safety systems should be serviced by a qualified RV technician.

Shop exact ignition boards and harnesses

Every linked product uses the image assigned to that UsedRVParts listing. Review condition, package contents and the original number before ordering.

Ignition boards — OEM, aftermarket and configurable

Connector conversion harnesses

Common control board questions

Does 91367 replace 91365?

No general interchange is supported. Dometic assigns 91367 to gas-only heaters and 91365 to particular gas/electric heaters.

Which adapter works with the 91365 board?

For older slide-style connector versions, the manufacturer identifies adapter 92074. The 92075 harness is separately documented for 91367 applications.

Does UIB 64 work with every Atwood ignition control?

No. Confirm the exact supported appliance and wiring configuration, then follow Dinosaur's jumper and connector instructions.

Will a new board cure every no-ignition failure?

No. Diagnose the thermostat, cut-off, electrode, voltage, wiring and gas-side components first.

Related water heater parts diagrams

Manufacturer reference: Dometic's replacement-parts chart. Confirm exact original components and installation requirements. Eligible UsedRVParts parts can be viewed or picked up by appointment in Kelowna.

Quick MPN links: 91363 · 91363MC · 91365 · 91365MC · 91367 · 91367MC · UIB 64 · 92075 · 92075MC

Recently viewed

New & Updated RV Parts Inventory — Check Back Often

We’re always adding new and used RV parts to our inventory, so be sure to check back regularly.

If you don’t see the part you need today, we may still have it in stock—our internal database includes thousands of new RV parts that are not yet listed online.

Text or email us with the product number or model, and we’ll check availability for you right away.

Our Products

RV Parts Newsletter

Sign up for upcoming promotions!