Descripción
The brand-new Lenco 15186-107 combines two low-mount Edge Mount trim tabs with a Pro Control Auto helm system. It suits installations where the height of a standard actuator bracket would be difficult to accommodate. Rather than relying solely on manual button presses, the supplied keypad and IMU work with the SD Pro actuators to adjust trim automatically on a properly installed system.
What makes it different?
Each 12 × 12-inch blade has raised edges for stiffness, and the actuator attaches closer to the trailing edge, reducing installation height by about 3 inches compared with a standard mount. This is the standard-finish stainless version, not Lenco's separately numbered electro-polished option. Auto and Assist control packages are different: this set includes the motion-sensing IMU used for Auto levelling.
Fit and measurements
- Manufacturer number: 15186-107; stock SKU 15186107
- Blade pair: Two 12-inch-long × 12-inch-wide Edge Mount stainless trim planes
- Material: 12-gauge 304 stainless steel; 1-inch turned-up edges and 1/8-inch hinge pins
- Drive pair: Two SD Pro 15189-001 actuators, 11.5-inch pin spacing and 2.25-inch travel
- Recommended boat size: 17–30 feet, subject to hull and transom layout
- Transom clearance: At least approximately 11 inches, with 2-inch hinge height
- Electrical setup: 12-volt Lenco Pro Control Auto
Components included
Lenco lists a Pro Control Auto keypad (15174-107), IMU (15180-001), two stainless blades, two SD Pro actuators with 6-foot Deutsch leads, two upper brackets with gland seals and two lower brackets. The network package also contains a Lenco 2K backbone, fused Micro-C power lead, six tees, two 6-foot Micro-C drops plus 15-foot and 25-foot drops, two Deutsch-to-Micro-C adapters, two 3-foot power pigtails and two non-Mercury wake-signal adapters.
Choosing the correct kit
Confirm that the transom provides the required clearance and that the boat's steering-station wiring, engine wake-signal interface and tab locations suit Pro Control Auto. This is 15186-107 standard finish; it should not be substituted with the manual 15185-106 Assist kit, conventional 100 Series tabs or electro-polished 15215-107. Check installed hull hardware and installation clearances before ordering.
Gastos estimados de envío
También te puede interesar
Visto recientemente
Inventario de piezas para vehículos recreativos nuevo y actualizado: consulte con frecuencia
Siempre estamos agregando piezas de RV nuevas y usadas a nuestro inventario, así que asegúrese de volver a consultarlo periódicamente.
Si no ve la pieza que necesita hoy, es posible que aún la tengamos en stock: nuestra base de datos interna incluye miles de piezas de vehículos recreativos nuevas que aún no están publicadas en línea.
Envíenos un mensaje de texto o correo electrónico con el número de producto o modelo y verificaremos la disponibilidad de inmediato.
Nuestras colecciones

