Brand New • Online Only

Jeep Wrangler JL & Gladiator Blackhawk Intake – K&N 71-1576

Ahorrar $155.00
K&N Filter MPN: 711576 UPC: 024844369208

Precio:
Precio de venta$469.00 Precio habitual$624.00

Gastos de envío calculados en la caja

Stock:
Solo quedan 2 unidades

Descripción

For a 3.6L Jeep Wrangler JL or Gladiator, this new K&N 71-1576 Blackhawk intake system replaces the original airbox and intake ducting with a matched high-flow assembly. Its large black DRYFLOW filter is washable and reusable without oil, and the powder-coated aluminum tube provides a clean, secure route to the throttle body. A formed steel heat shield helps keep hot under-hood air away from the filter.

Which Jeeps does it fit?

The 71-1576 installation guide identifies Wrangler JL, 2018–2023, and Gladiator, 2020–2023, with the 3.6L V6. It includes applicable eTorque versions, but does not accommodate a body lift. Before ordering, confirm the vehicle's engine, intake arrangement and emissions-specific approval.

What you receive

One 3.25-inch-OD aluminum intake tube, one RU-3107HBK dry synthetic cone filter, protective heat shield and edge trim, filter adapter, two connecting hoses, five clamps, sensor grommet, mounting spacers, standoffs and fasteners. The intake reuses the vehicle's temperature sensor and crankcase vent connection.

Useful technical details

  • Exact K&N part number: 71-1576 (warehouse SKU 711576).
  • Filter medium: black, non-woven synthetic; tubing: textured-black aluminum; five hose clamps included.
  • Tested on a 2018 Wrangler 3.6L: 9.1 additional hp at 5,400 rpm and 10.4 lb-ft of torque at 3,000 rpm; vehicle results vary.
  • Shipping package: 24.1 in. long × 15.5 in. wide × 14.5 in. high, weighing 10.4 lb (4.7 kg).
  • No-Hassle Lifetime Limited Warranty from K&N.

Fitting and maintenance

Allow roughly 90 minutes with ordinary hand tools. Retain the factory inlet temperature sensor and seal during removal, mount the intake to the factory locations, and check couplers, clamps and hose routing before driving. The dry filter can be cleaned at approximately 50,000-mile intervals under normal road conditions; dusty use calls for earlier inspection. Use cleaner made for synthetic filters, not oil.

For vehicles registered in California or another emissions-controlled jurisdiction, verify the part's exact executive-order eligibility against the vehicle's emissions family before installation.

Gastos estimados de envío

También te puede interesar

Visto recientemente

Inventario de piezas para vehículos recreativos nuevo y actualizado: consulte con frecuencia

Siempre estamos agregando piezas de RV nuevas y usadas a nuestro inventario, así que asegúrese de volver a consultarlo periódicamente.

Si no ve la pieza que necesita hoy, es posible que aún la tengamos en stock: nuestra base de datos interna incluye miles de piezas de vehículos recreativos nuevas que aún no están publicadas en línea.

Envíenos un mensaje de texto o correo electrónico con el número de producto o modelo y verificaremos la disponibilidad de inmediato.

Nuestras colecciones