Brand New • Online Only

Injen PowerFlow PF2013RB Black Intake Kit for Tacoma & 4Runner

Ahorrar $132.00
Injen MPN: PF2013RB UPC: 843115030247

Precio:
Precio de venta$400.00 Precio habitual$532.00

Gastos de envío calculados en la caja

Stock:
Solo quedan 3 unidades

Descripción

Upgrade the air intake on an eligible Toyota turbo engine with the new Injen PF2013RB PowerFlow kit. This is the black polyethylene tube version, supplied with an Injen dry filter and a dedicated heat shield, rather than the Flat Dark Earth or cement-grey versions of the same product family.

Compatibility first

Fitment covers these 2.4L turbo four-cylinder applications: Tacoma 2024–2025, Land Cruiser 2024–2025 and 4Runner 2025–2026. These are engine-specific applications; TRD Pro and Trailhunter hybrid configurations are excluded. Consult the precise model/trim information before installation.

Kit construction

  • Part number: PF2013RB
  • Tube: Black, high-strength cross-linked polyethylene with shaped intake bends
  • Filter assembly: Serviceable SuperNano-Web dry filter; replacement part X-1051-BB
  • Heat control: Custom-engineered black heat shield
  • Airflow transition: Bolt-on velocity stack
  • Installation hardware: Reinforced couplers and clamps for the listed application
  • Calibration: Built around stock engine programming
  • Warranty: Limited lifetime manufacturer coverage for qualifying defects

Installation guidance

Allow enough room for the filter and heat shield and secure every joint according to Injen's instructions. Replace or service the filter on schedule, especially after dusty travel. PF2013-series dyno testing measured gains of up to 15 hp and 19 lb-ft while retaining the stock engine tune; actual results vary. Emissions restriction: PF2013RB is not currently CARB-exempt, is not available for purchase in California and must not be used on California-registered vehicles. Verify regional emissions requirements before ordering.

Before beginning the intake swap

Check the kit against Injen's published bill of materials: black roto-moulded tube, filter, heat shield, bolt-on velocity stack, two connecting hoses, four clamps, six fastening screws and rubber bulb trim. The original MAF sensor is moved into the new assembly, not included as a replacement. Use the PF2013 fitting instructions for the installation sequence and follow the dry-filter cleaning procedure, which differs from that for an oiled filter.

Gastos estimados de envío

También te puede interesar

Visto recientemente

Inventario de piezas para vehículos recreativos nuevo y actualizado: consulte con frecuencia

Siempre estamos agregando piezas de RV nuevas y usadas a nuestro inventario, así que asegúrese de volver a consultarlo periódicamente.

Si no ve la pieza que necesita hoy, es posible que aún la tengamos en stock: nuestra base de datos interna incluye miles de piezas de vehículos recreativos nuevas que aún no están publicadas en línea.

Envíenos un mensaje de texto o correo electrónico con el número de producto o modelo y verificaremos la disponibilidad de inmediato.

Nuestras colecciones