Brand New • Online Only

aFe 54-13085V Ram 2500/3500 D2 Dry-Filter Stage-2 Intake

Ahorrar $38.00
aFe POWER MPN: 5413085V UPC: 802959547045

Precio:
Precio de venta$377.00 Precio habitual$415.00

Gastos de envío calculados en la caja

Stock:
Solo queda 1 unidad

Descripción

New Stage-2 intake with maintenance-free D2 filter media

For the 2025 or 2026 Ram 2500/3500 equipped with a 6.7L Cummins diesel, aFe POWER's 54-13085V supplies a complete replacement air-intake arrangement. A molded black intake duct and open-element housing work with the truck's existing outside-air inlet; the large blue D2 Dura-Dry element is visible from the top for convenient inspection.

Know which filter you're getting

The blue filter is D2 Dura-Dry non-woven synthetic media, rather than a reusable oiled cotton-gauze filter. There is no cleaning, drying or re-oiling procedure: replace the entire filter when necessary. The exact service element is 24-90214V. The separate aFe 28-10033 pre-filter is an optional accessory and does not come with this kit. The 54-13085R is a different Pro 5R version.

What the kit changes

The open-top housing protects the filter area while leaving the element accessible and allowing more induction sound than a fully sealed airbox. The heat-resistant XLPE tube creates a purpose-shaped route to the turbo. A silicone elbow reducer provides flexibility at the connection, with two metal clamps securing the joints. This exact configuration is intended for 2025–2026 Cummins trucks, not the earlier 2019–2024 6.7L air-intake layout.

Specifications and included pieces

aFe manufacturer MPN 54-13085V (supplier SKU 5413085V)
Product series Magnum FORCE Stage-2 open-element cold-air intake
Filter D2 Dura-Dry, replace-only synthetic; MPN 24-90214V
Housing / tube Black cross-linked polyethylene (XLPE)
Package Filter, molded tube, open housing, silicone reducer elbow, 37.25-inch edge trim, two worm-drive clamps and M4 Torx sensor screw
Rated bench airflow 455 CFM at 7 in H₂O; up to 11% above the tested factory setup

Fitting considerations

The manufacturer's installation sequence requires removing front intake-scoop trim, the original housing and ducting, then transferring the factory temperature sensor, three airbox grommets, crankcase-hose spring clamp and scoop. Standard hand tools and a T20 Torx bit are specified. Refit the original scoop and trim after securing the intake. Check all fasteners, hoses and sensor connections again after 100–200 miles.

Use restriction: No current CARB exemption is listed for the part, and aFe does not allow its sale or use on California-registered vehicles. This product is brand-new despite being offered through UsedRVParts.ca.

Gastos estimados de envío

También te puede interesar

Visto recientemente

Inventario de piezas para vehículos recreativos nuevo y actualizado: consulte con frecuencia

Siempre estamos agregando piezas de RV nuevas y usadas a nuestro inventario, así que asegúrese de volver a consultarlo periódicamente.

Si no ve la pieza que necesita hoy, es posible que aún la tengamos en stock: nuestra base de datos interna incluye miles de piezas de vehículos recreativos nuevas que aún no están publicadas en línea.

Envíenos un mensaje de texto o correo electrónico con el número de producto o modelo y verificaremos la disponibilidad de inmediato.

Nuestras colecciones