Brand New • Online Only

Injen PowerFlow PF2013RB Black Intake Kit for Tacoma & 4Runner

Economisez $132.00
Injen MPN: PF2013RB UPC: 843115030247

Prix:
Prix réduit$400.00 Prix normal$532.00

Frais de port calculés au paiement

Stock:
Plus que 3 en stock

Description

Upgrade the air intake on an eligible Toyota turbo engine with the new Injen PF2013RB PowerFlow kit. This is the black polyethylene tube version, supplied with an Injen dry filter and a dedicated heat shield, rather than the Flat Dark Earth or cement-grey versions of the same product family.

Compatibility first

Fitment covers these 2.4L turbo four-cylinder applications: Tacoma 2024–2025, Land Cruiser 2024–2025 and 4Runner 2025–2026. These are engine-specific applications; TRD Pro and Trailhunter hybrid configurations are excluded. Consult the precise model/trim information before installation.

Kit construction

  • Part number: PF2013RB
  • Tube: Black, high-strength cross-linked polyethylene with shaped intake bends
  • Filter assembly: Serviceable SuperNano-Web dry filter; replacement part X-1051-BB
  • Heat control: Custom-engineered black heat shield
  • Airflow transition: Bolt-on velocity stack
  • Installation hardware: Reinforced couplers and clamps for the listed application
  • Calibration: Built around stock engine programming
  • Warranty: Limited lifetime manufacturer coverage for qualifying defects

Installation guidance

Allow enough room for the filter and heat shield and secure every joint according to Injen's instructions. Replace or service the filter on schedule, especially after dusty travel. PF2013-series dyno testing measured gains of up to 15 hp and 19 lb-ft while retaining the stock engine tune; actual results vary. Emissions restriction: PF2013RB is not currently CARB-exempt, is not available for purchase in California and must not be used on California-registered vehicles. Verify regional emissions requirements before ordering.

Before beginning the intake swap

Check the kit against Injen's published bill of materials: black roto-moulded tube, filter, heat shield, bolt-on velocity stack, two connecting hoses, four clamps, six fastening screws and rubber bulb trim. The original MAF sensor is moved into the new assembly, not included as a replacement. Use the PF2013 fitting instructions for the installation sequence and follow the dry-filter cleaning procedure, which differs from that for an oiled filter.

Estimer la livraison

Vous aimerez peut-être aussi

Récemment consulté

Inventaire de pièces détachées pour VR, nouveau et mis à jour – Consultez-le régulièrement

Nous ajoutons constamment des pièces neuves et d'occasion pour véhicules récréatifs à notre inventaire, alors assurez-vous de consulter régulièrement notre site.

Si vous ne trouvez pas la pièce dont vous avez besoin aujourd'hui, nous l'avons peut-être encore en stock : notre base de données interne comprend des milliers de pièces neuves pour véhicules de loisirs qui ne sont pas encore répertoriées en ligne.

Envoyez-nous un SMS ou un e-mail avec le numéro de produit ou le modèle , et nous vérifierons immédiatement sa disponibilité pour vous.

Nos collections