Description
New Stage-2 intake with maintenance-free D2 filter media
For the 2025 or 2026 Ram 2500/3500 equipped with a 6.7L Cummins diesel, aFe POWER's 54-13085V supplies a complete replacement air-intake arrangement. A molded black intake duct and open-element housing work with the truck's existing outside-air inlet; the large blue D2 Dura-Dry element is visible from the top for convenient inspection.
Know which filter you're getting
The blue filter is D2 Dura-Dry non-woven synthetic media, rather than a reusable oiled cotton-gauze filter. There is no cleaning, drying or re-oiling procedure: replace the entire filter when necessary. The exact service element is 24-90214V. The separate aFe 28-10033 pre-filter is an optional accessory and does not come with this kit. The 54-13085R is a different Pro 5R version.
What the kit changes
The open-top housing protects the filter area while leaving the element accessible and allowing more induction sound than a fully sealed airbox. The heat-resistant XLPE tube creates a purpose-shaped route to the turbo. A silicone elbow reducer provides flexibility at the connection, with two metal clamps securing the joints. This exact configuration is intended for 2025–2026 Cummins trucks, not the earlier 2019–2024 6.7L air-intake layout.
Specifications and included pieces
| aFe manufacturer MPN | 54-13085V (supplier SKU 5413085V) |
|---|---|
| Product series | Magnum FORCE Stage-2 open-element cold-air intake |
| Filter | D2 Dura-Dry, replace-only synthetic; MPN 24-90214V |
| Housing / tube | Black cross-linked polyethylene (XLPE) |
| Package | Filter, molded tube, open housing, silicone reducer elbow, 37.25-inch edge trim, two worm-drive clamps and M4 Torx sensor screw |
| Rated bench airflow | 455 CFM at 7 in H₂O; up to 11% above the tested factory setup |
Fitting considerations
The manufacturer's installation sequence requires removing front intake-scoop trim, the original housing and ducting, then transferring the factory temperature sensor, three airbox grommets, crankcase-hose spring clamp and scoop. Standard hand tools and a T20 Torx bit are specified. Refit the original scoop and trim after securing the intake. Check all fasteners, hoses and sensor connections again after 100–200 miles.
Use restriction: No current CARB exemption is listed for the part, and aFe does not allow its sale or use on California-registered vehicles. This product is brand-new despite being offered through UsedRVParts.ca.
Estimer la livraison
Vous aimerez peut-être aussi
Récemment consulté
Inventaire de pièces détachées pour VR, nouveau et mis à jour – Consultez-le régulièrement
Nous ajoutons constamment des pièces neuves et d'occasion pour véhicules récréatifs à notre inventaire, alors assurez-vous de consulter régulièrement notre site.
Si vous ne trouvez pas la pièce dont vous avez besoin aujourd'hui, nous l'avons peut-être encore en stock : notre base de données interne comprend des milliers de pièces neuves pour véhicules de loisirs qui ne sont pas encore répertoriées en ligne.
Envoyez-nous un SMS ou un e-mail avec le numéro de produit ou le modèle , et nous vérifierons immédiatement sa disponibilité pour vous.
Nos collections



