Dometic 9200 power awnings have different service parts for the motorized drive head, the opposite idler head, exterior head covers and the wall-mounted support arms. A cracked plastic cap does not require a replacement motor, and a damaged support arm is not the same part as a drive head. Start with the awning model and the component that actually needs repair.

Which awning assembly are you replacing?

Drive motor / drive head

3317084.000U is the black powered drive-head/motor kit for selected 9200 Power Patio Awning configurations. It does not include the entire awning.

Drive and idler head covers

3317085.000U supplies black outside protective covers for both ends. It is not a powered motor, gearbox or idler-head mechanism.

Support arms

Compare 3312487.006U single standard arm with full standard 9200 and basement arm sets. Geometry and installation height must agree.

Where the parts sit on the awning

Original component-location illustration for identification only, not a measured installation drawing. Support arms run from the awning assembly to the RV wall on both ends.

Standard arm, basement arm or single replacement?

The Dometic 8962002.400UL is a standard-style full arm set for selected 9200 power awnings. The 8962001.400UL basement model has a different arm geometry intended for installations with basement compartments and the related clearance requirements. Do not substitute these based on colour or awning fabric width alone.

3312487.006U is a black half-set (one arm), listed for certain 9100 and 9200 powered awnings with straight-sided installations. A half-set is not a matching left-and-right hardware pair. Compare the original arm family and the full awning's installation specifications before replacing any structural hardware.

Important awning safety: Powered awning arms can be under stored spring or mechanical tension, and motor wiring creates electrical hazards. Secure the awning and follow the Dometic repair procedure for the exact installed model. Do not release torsion or arm components without appropriate service equipment and training.

Dometic 9200 replacement part-number chart

MPN Component Included assembly
3317084.000U Motorized drive-side head Drive-head assembly with motor
3317085.000U Protective covers, not powered internals Black drive-side and idler-side head covers
3312487.006U Single replacement support arm One black fixed-pitch arm; not a full left/right set
8962002.400UL Complete standard-pitch arm set Matched arm pair for compatible 9200 installations
8962001.400UL Complete basement-style arm set Matched shortened-channel arm pair

Check the original part before ordering

  1. Record the awning series and product ID. Confirm that the installed unit is a compatible Dometic 9200 rather than a similar 9100 or other power awning.
  2. Identify the end and fault. The motor drive side, idler side, covers and wall-mounted support hardware have separate replacements.
  3. For an arm, check configuration. Measure mounting height and compare standard versus basement geometry, left/right requirements and finish.
  4. For a motor or cover, check the existing assembly. Compare the original part number and Dometic's model-specific repair drawing before assuming a newer-looking head will fit.

Find the matching Dometic power awning parts

Common replacement questions

Does 3317085.000U contain the drive motor?

No. It is the black drive and idler head cover kit. The separate 3317084.000U is the identified powered drive-head-and-motor component.

Are basement arms and standard arms interchangeable?

Not by appearance. Different geometry and wall-clearance requirements apply. Match the original Dometic hardware number and installation drawing.

Is 3312487.006U a complete left/right arm set?

No. It is listed as a half-set containing a single arm. A full arm pair is a different product.

Does the 3317084.000U kit replace the fabric and roller tube?

No. This is a powered drive-head/motor assembly, not the complete roller-and-fabric awning.

Can I inspect used awning hardware in Kelowna?

UsedRVParts offers viewing and pickup for eligible locally held items by appointment. These particular linked products are listed as new; confirm fulfilment details on each product page.

Other awning reference pages

For the factory configuration and numbered component breakdown, refer to the the manufacturer installation and service documentation for your exact Dometic 9200 model. Confirm the document matches your installed assembly before use.

Quick part links: 3317084.000U · 3317085.000U · 3312487.006U · 8962002.400UL · 8962001.400UL

Récemment consulté

Inventaire de pièces détachées pour VR, nouveau et mis à jour – Consultez-le régulièrement

Nous ajoutons constamment des pièces neuves et d'occasion pour véhicules récréatifs à notre inventaire, alors assurez-vous de consulter régulièrement notre site.

Si vous ne trouvez pas la pièce dont vous avez besoin aujourd'hui, nous l'avons peut-être encore en stock : notre base de données interne comprend des milliers de pièces neuves pour véhicules de loisirs qui ne sont pas encore répertoriées en ligne.

Envoyez-nous un SMS ou un e-mail avec le numéro de produit ou le modèle , et nous vérifierons immédiatement sa disponibilité pour vous.

Nos produits

Bulletin d'information sur les pièces de camping-car

Inscrivez-vous pour les promotions à venir !