BAL Accu-Slide Cable Slide-Out Parts & Motor Diagram

The BAL Accu-Slide uses a motor-driven chain and stainless-steel cables routed over pulleys to move an RV slide-out room. Its compact motor assemblies, left and right pulley brackets, cable adjusters and rubber keeper grommets can be serviced separately. The correct parts depend on the Accu-Slide version and the identification label on the mechanism.

View Available Parts With Photos

Identify your Accu-Slide version

BAL has separate component drawings for ABS, G4/Econo and Hybrid slide-out systems. Although some service parts are shared, the jambs, pulley arrangements and seals can differ. Check the label on the slide-out mechanism and compare the original part before ordering.

View BAL’s pulley and cable-adjuster parts drawings

This G4/Econo drawing identifies the left and right pulley brackets, cable-chain adjuster, grommet and double-back components. Tap the diagram to open a larger view.

Motor and gearbox identification

Four BAL compact motor-and-gearbox kits look similar but differ by standard versus high torque and whether the sprocket points up or down. Check the label and actual sprocket position before buying a replacement.

The 21900002 is BAL's high-torque, sprocket-up compact assembly. The 25076-1 gearbox kit services the R25076 gearbox used by the matching compact assemblies; it is not a complete motor replacement and is different from the larger P22307/P22327/P22332 geared-motor designs.

Compare all four compact motors and the larger motor assemblies (manufacturer PDF).

View compact motor identification photographs

Cable-chain hardware and pulley brackets

The 22302L is the left-hand corner pulley bracket and the 22302R is the right-hand version. Match the existing bracket shape, side and cable routing. Double-back arrangements use other corner-bracket numbers, including 25042 and 25043.

The 22504 adjustment kit joins the cable and chain for the appropriate standard arrangement. BAL identifies 22509 as a different double-back adjustment kit. The 854195 rubber grommet is a small cable-retaining component shown in BAL's G4/Econo and Hybrid parts illustrations.

Quick component-number reference

Before servicing the slide-out

A loose or damaged cable may be caused by pulley alignment or improper adjustment, not necessarily the motor. Follow the correct BAL service procedure for your slide type. Disconnect power and support the room as directed before working on the mechanism; cable tension and moving slide rooms can cause injury or damage if serviced incorrectly.

For cable routing, adjustment and motor replacement procedures, see BAL's official Accu-Slide technical documents.

Other slide-out parts guides

Working on a different drive design? See the Lippert SlimRack motor and control guide or our Schwintek In-Wall slide-out parts guide. Their motors and drive components are not direct substitutes for BAL Accu-Slide parts.

Find Accu-Slide replacement parts by photo

High-torque compact motor kit21900002

68ZY motor and gearbox, sprocket-up version. Match the motor label and drive orientation.

View this replacement part

Left-hand corner pulley bracket22302L

Left-side corner pulley assembly used with the matching Accu-Slide cable route.

View this replacement part

Right-hand corner pulley bracket22302R

Right-side counterpart to 22302L; the brackets are handed and have different mounting layouts.

View this replacement part

Cable-chain adjustment bracket kit22504

Adjustment connector for the specified standard cable-chain arrangement, not the double-back 22509 kit.

View this replacement part

Compact-motor gearbox service kit25076-1

Service gearbox for BAL R25076 compact assemblies; supplied with its mounting bracket.

View this replacement part

Cable keeper grommet854195

Rubber cable grommet with approximately 0.281-inch inside diameter and 0.625-inch outside diameter.

View this replacement part