Red wheel chock
A grooved wheel chock designed to help prevent a parked tire from rolling, with a nylon pull cord to assist removal.
View A10-0908Valterra RV Wheel Chock & Frame Stabilizer: Components and Setup
A wheel chock and a frame stabilizer tackle two different kinds of movement. The chock sits at a tire to help prevent the RV or trailer from rolling. Valterra's folding cross-frame stabilizer braces against appropriate frame or bumper points to reduce movement while parked. A stabilizer does not replace a wheel chock, a parking brake or a leveling jack.
Two Valterra components and their jobs
| Part | Where it works | Primary purpose |
|---|---|---|
| A10-0908 | Against a tire, on a suitable surface | Resist wheel movement |
| 020106 | Beneath suitable frame or bumper contact points | Reduce side-to-side or front-to-back sway |
Wheel chock A10-0908
Valterra's red wheel chock has a grooved contact surface and a nylon cord for pulling it away when you're ready to move. Use wheel chocks of an appropriate size and quantity for the RV, wheel and surface. Position them according to the vehicle's parking instructions; do not use a loose stabilizer in their place.
Folding stabilizer 020106: identify the assembly
Valterra specifies the folding unit for 14–28-inch frame clearances. The illustrated manufacturer instructions identify an upper contact rail, adjustable folding legs and feet, foot pins, S-hooks, and a ratchet strap. These are assembly components shown for identification; this page does not claim they are offered as individual replacement parts.
| Component | What to check when setting up |
|---|---|
| Upper contact rails | Contact the RV's frame or appropriate bumper, never fragile plastic or body panels |
| Adjustable legs and feet | Feet rest flat on firm ground; legs adjust to an appropriate angle |
| Foot pins and S-hooks | Both hooks attach to the foot pins as shown in the factory instructions |
| Ratchet strap | Apply only the recommended firm tension; do not use the assembly to raise the RV |
Valterra recommends firm ground and an approximate 45–60-degree leg angle. Once the contact rails touch the frame or bumper, the instructions limit additional ratchet movement to no more than two handle cycles. Over-tightening can damage the stabilizer. The device must not be used as a lifting jack.
See the matching products
Folding cross-frame stabilizer
Folding stabilizer for the RV frame or bumper with 14–28-inch ground clearance; used after the RV is safely parked.
View 020106Manufacturer setup photographs and instructions
Valterra's illustrated RV stabilizer instructions (PDF) show the folding legs, foot pins, ratchet strap and frame contact arrangement. Open the official instructions before first use.
Manufacturer product references: A10-0908 red wheel chock and 020106 folding frame stabilizer.
Récemment consulté
Inventaire de pièces détachées pour VR, nouveau et mis à jour – Consultez-le régulièrement
Nous ajoutons constamment des pièces neuves et d'occasion pour véhicules récréatifs à notre inventaire, alors assurez-vous de consulter régulièrement notre site.
Si vous ne trouvez pas la pièce dont vous avez besoin aujourd'hui, nous l'avons peut-être encore en stock : notre base de données interne comprend des milliers de pièces neuves pour véhicules de loisirs qui ne sont pas encore répertoriées en ligne.
Envoyez-nous un SMS ou un e-mail avec le numéro de produit ou le modèle , et nous vérifierons immédiatement sa disponibilité pour vous.
Nos produits