A truck camper that overhangs the truck's rear bumper may require extra distance between the receiver and a trailer coupler. The Torklift SuperTruss is a dual-tube hitch extension built for compatible Torklift SuperHitch dual-receiver systems. Choose its length by the actual camper overhang, and compare the trailer and tongue-weight ratings for your entire towing setup.

Manufacturer length and capacity reference

The Torklift SuperTruss official capacity chart lists trailer and tongue limits for every length. Torklift's illustrated installation instructions show the upper and lower tubes, lateral chains, collars, shackles and adjustment points.

The ratings below apply under Torklift's specified SuperHitch Original 20K or SuperHitch Magnum 30K conditions. A SuperHitch Hero or other configuration may have different ratings. Always check the manual for your actual hitch.

Compare available extensions and towing limits

Part Length Weight carrying: trailer / tongue With weight distribution: trailer / tongue Wiring harness*
E1524 24 in 7,500 / 750 lb 14,000 / 1,400 lb W6024
E1528 28 in 7,500 / 750 lb 12,000 / 1,200 lb W6028
E1532 32 in 6,500 / 650 lb 12,000 / 1,200 lb W6032
E1536 36 in 6,500 / 650 lb 12,000 / 1,200 lb W6036
E1542 42 in 6,000 / 600 lb 12,000 / 1,200 lb W6042
E1548 48 in 6,000 / 600 lb 12,000 / 1,200 lb W6048
E1560 60 in 5,000 / 500 lb 10,000 / 1,000 lb W6060

*Wiring harness: W60-series numbers are Torklift's matching extension harnesses. Match the electrical connector and select wiring separately; they are not assumed to be included with each SuperTruss.

Why the two rating columns matter

Weight carrying is the limit when towing without a weight-distributing hitch. The higher ratings apply only with a compatible, correctly adjusted weight-distribution system. For example, E1524 permits a maximum 7,500 lb trailer / 750 lb tongue in weight-carrying use, or 14,000 lb trailer / 1,400 lb tongue under the specified weight-distributing arrangement. E1560 at 60 inches is rated 5,000 / 500 lb without weight distribution, or 10,000 / 1,000 lb with it.

Use the lowest relevant rating of the truck, receiver, extension, ball mount, coupler, trailer and weight-distribution equipment. The extension does not increase your truck's towing, payload or combined-weight limits. Verify the receiver family and any installed adapter before ordering.

Product photographs and direct links

E1524 — 24-inch extension

Torklift E1524 24-inch dual-tube SuperTruss hitch extension product photograph

7,500 lb trailer / 750 lb tongue without weight distribution. Higher ratings require the specified weight-distributing system.

View E1524 product

E1542 — 42-inch extension

Torklift E1542 42-inch dual-tube SuperTruss hitch extension product photograph

6,000 lb trailer / 600 lb tongue without weight distribution. Higher ratings require the specified weight-distributing system.

View E1542 product

E1560 — 60-inch extension

Torklift E1560 60-inch dual-tube SuperTruss hitch extension product photograph

5,000 lb trailer / 500 lb tongue without weight distribution. Higher ratings require the specified weight-distributing system.

View E1560 product

The comparison chart above links directly to all seven stocked extension lengths, including the 28-, 32-, 36- and 48-inch models.

Measure the length you need

With the camper installed, measure from the face of the truck's rear bumper to the outer edge of the camper's rear bumper. This provides Torklift's minimum extension length measurement. Without the camper installed, measure from the inside front of the truck bed to the outside face of the truck's rear bumper, then subtract that from the camper floor length measured from its front rubber bumpers to its outside rear edge.

Allow for turning and trailer clearance, then select the shortest approved SuperTruss that meets your installation's measured requirements. Do not cut, drill or modify an extension to alter its length.

Assembly, chains and installation checks

The SuperTruss assembly uses an upper receiver tube, lower compression tube, clamp collars, bolts and lateral-support safety chains with shackles and eye-to-eye turnbuckles. Short and long extensions use different hardware quantities. The lateral chains must be installed and correctly tensioned: they are structural support for the extension, not substitutes for the trailer's own safety chains.

Follow the manufacturer's exact collar and fastener instructions. Torklift notes that some SuperHitch Magnum installations require a reducer sleeve, and certain hitch configurations require longer extensions to clear the support chains. Never use SuperTruss in a regular single-receiver hitch or a modified non-SuperHitch receiver.

Find related towing equipment

Browse trailer receiver hitches, weight-distribution hitches and parts or the Torklift equipment collection for related products.

Récemment consulté

Inventaire de pièces détachées pour VR, nouveau et mis à jour – Consultez-le régulièrement

Nous ajoutons constamment des pièces neuves et d'occasion pour véhicules récréatifs à notre inventaire, alors assurez-vous de consulter régulièrement notre site.

Si vous ne trouvez pas la pièce dont vous avez besoin aujourd'hui, nous l'avons peut-être encore en stock : notre base de données interne comprend des milliers de pièces neuves pour véhicules de loisirs qui ne sont pas encore répertoriées en ligne.

Envoyez-nous un SMS ou un e-mail avec le numéro de produit ou le modèle , et nous vérifierons immédiatement sa disponibilité pour vous.

Nos produits

Bulletin d'information sur les pièces de camping-car

Inscrivez-vous pour les promotions à venir !