Furrion Vision S+ RV Camera Systems, Parts & Installation Diagrams

The Furrion Vision S+ camera system uses high-resolution 1080p cameras and a 5-inch or 7-inch monitor to show what is happening behind and alongside your RV. There are several kit combinations, so compare the exact FOS model number before choosing a complete system or an additional camera.

The Vision S+ generation is different from the earlier Vision S. Vision S+ cameras and monitors are not interchangeable with Vision 1, Vision 2 or Vision S products.

Compare camera systems and replacement components

7-inch monitor + sharkfin cameraFOS7HTASF

One 1080p rear/doorway sharkfin camera and a 7-inch display.

View this product

7-inch monitor + three camerasFOS7HTAEN

A rear/doorway sharkfin camera plus left and right marker-light side cameras.

View this product

7-inch monitor + four camerasFOS7HTAPM

Sharkfin, rear marker-light camera, and two side marker-light cameras.

View this product

5-inch monitor + sharkfin cameraFOS5HTASF

Compact 5-inch display and one rear/doorway sharkfin camera.

View this product

Left and right side camerasFCEFDTASH

Two Vision S+ 1080p side cameras, each with an amber LED marker light; monitor not included.

View this product

Replacement sharkfin cameraFCNFDTASF

Standalone Vision S+ 1080p camera with bracket for rear or doorway placement.

View this product

Which Vision S+ camera kit do you need?

Single-camera kits are suited to an RV needing a rear or doorway view. Three-camera kits add both sides of the trailer. The FOS7HTAPM four-camera kit adds a separate rear marker-light camera alongside the sharkfin and left/right side cameras. All the listed configurations are Vision S+ products.

Furrion camera and monitor installation diagrams

The Furrion manual shows the 5-inch and 7-inch monitors, rear sharkfin camera, side cameras, marker-light assemblies, mounting hardware and electrical connections. It also shows where to find the camera pairing button and how to mount the included display stand.

Open the illustrated installation manual (PDF)

Furrion Vision S+ official support and manuals

Identify each major component

• Monitor: touchscreen display with two antennas, USB-C power connection and a ball-joint mounting point.
• Sharkfin camera: rear or doorway camera with its own antenna, infrared LEDs and pairing control.
• Left/right side cameras: outward-facing cameras with integrated amber marker lights, identified as the FCEFDTASH pair.
• Rear marker-light camera: an additional rear camera included with the FOS7HTAPM system.
• Mounting and power accessories: a windshield mount, table stand and vehicle power cable supplied with the complete kits listed above.

Replacing a rear camera or adding side coverage

The FCNFDTASF sharkfin camera is sold separately for compatible Vision S+ systems, so a damaged rear or doorway camera need not require a complete replacement monitor kit. The FCEFDTASH side-camera pair adds left and right views to a compatible Vision S+ setup with available camera channels. Check your existing monitor and mounting position before ordering.

Power and camera pairing

The monitor uses a 5-volt power supply through its USB-C connection, while the cameras connect to the vehicle's appropriate DC supply as shown in Furrion's wiring diagrams. Disconnect electrical power before installing a camera or working on marker-light wiring.

After installation, use the monitor's camera settings and the pairing button on the replacement camera to establish the wireless connection. The illustrated Furrion manual provides the pairing steps and connector orientation. Video recording requires a suitable memory card, which is separate from the camera system.

Have the earlier Vision S system?

If the label identifies your system as Vision S rather than Vision S+, use the Furrion Vision S replacement-parts and installation guide for its own monitor, antenna, bracket and power components.