Trying to identify an existing Go Power Solar Flex panel or expansion kit? The FLEX-110 and FLEX-220 kits include charging equipment; the FLEX-110E adds a panel to a suitable system. Match the label and check the installed controller before buying a replacement or expanding the array.

How a Solar Flex panel attaches and connects

Go Power provides adhesive or fastener mounting options for these flexible modules. Their panel design can follow a gently curved surface, up to the manufacturer's stated 30-degree curvature. Appropriate adhesive or sealant is not included; its selection depends on the actual roof material.

Flexible panel surface110W laminated monocrystalline module; position clear of rooftop obstructions
Mounting layerApproved adhesive or module-grommet screws, following roof instructions
RV roof membrane and structureSurface preparation, fastening and sealing specific to the RV
Solar module connectorsPanel PV positive and negative leads
Roof cable entry and PV wiringConnector, cable and protection selected for the installed array
Solar controller → batteryCorrect controller profile and capacity required for the battery bank
Original functional illustration; not a drilling template, adhesive coverage pattern or wiring schematic.
Mounting warning: Go Power states that adhesive mounting can be permanent. Check placement and module operation before fixing it to the roof. Secure every panel using the approved installation method and seal each roof penetration properly.

Know what is and is not included

Exact kit Rated PV power Panel configuration Package distinction
GP-FLEX-110 110W One flexible 110W panel Charging kit with controller; verify the controller revision
GP-FLEX-110E 110W One additional 110W panel Expansion hardware; no separate solar charge controller
GP-FLEX-220 220W Two 110W flexible modules Complete kit with charging equipment

Go Power identifies the FLEX-110E as a 110W expansion package with a module, solar branch connectors, mounting screws and reverse-blocking diodes. It does not supply a new charge controller. A complete GP-FLEX-110 has 25-foot positive and negative solar output cables and a model-specific 30A controller; confirm whether the shipped unit has the current or older controller revision.

Some Go Power publications show differing module electrical specifications across revisions. Compare the panel's own identification label and exact datasheet before adding modules in series or parallel. Do not assume all Go Power 110W panels share the same Voc, Imp or connector type.

Compare exact kit photos and model names

Original Go Power mounting diagrams

The factory Solar Flex installation manual shows panel positioning, roof-attachment options, cable routing and the required weather sealing. Its electrical diagrams show how to use the correct charge controller with the chosen solar modules.

Go Power Solar Flex installation manual (PDF) · FLEX-110 kit specifications · FLEX-110E expansion contents

Installation: Verify the RV roof construction, approved mounting chemistry, waterproofing instructions and panel electrical ratings. PV circuits remain hazardous in sunlight. Use qualified installation help for structural penetrations or electrical changes.

Visto recientemente

Inventario de piezas para vehículos recreativos nuevo y actualizado: consulte con frecuencia

Siempre estamos agregando piezas de RV nuevas y usadas a nuestro inventario, así que asegúrese de volver a consultarlo periódicamente.

Si no ve la pieza que necesita hoy, es posible que aún la tengamos en stock: nuestra base de datos interna incluye miles de piezas de vehículos recreativos nuevas que aún no están publicadas en línea.

Envíenos un mensaje de texto o correo electrónico con el número de producto o modelo y verificaremos la disponibilidad de inmediato.

Nuestros productos

Boletín informativo de piezas para vehículos recreativos

¡Regístrate para próximas promociones!