B&B 94314–94317 Wide RV Access Hatches: Cord Door Guide

For an RV's wider exterior access compartment, B&B Molders offers a family of hatches with a 6 × 11¹⁄₁₆-inch wall opening and a 7¾ × 12⅝-inch outside trim. The important difference is the door and latch arrangement: standard multi-purpose access versus dedicated small cord pass-throughs.

Find the correct wide hatch

Choose standard access or dual cord access

94314 and 94315: standard access doors

The white 94314 is keyed, while the black 94315 uses a thumb latch. Both are ordinary multi-purpose open-back hatches of the same size. They are not listed with the two dedicated vermin-access cord doors used on the models below.

94316 and 94317: two smaller cord pass-through doors

The keyed 94316 (white) and 94317 (black) have two smaller access doors intended to accommodate compatible 30-amp and 50-amp RV power cords. The cord passes through the hatch; the hatch itself is not an outlet, power adapter or electrical protection device. Check your cord's actual outer diameter and the original pass-through opening.

Compare the four product photographs

94314 — Wide white keyed hatch

White wide open-back hatch with a keyed door.

View 94314 product

94315 — Wide black thumb-latch hatch

Black wide open-back hatch with a thumb-operated latch.

View 94315 product

94316 — Wide white dual cord-access hatch

White keyed hatch with the factory's two vermin-access cord doors.

View 94316 product

94317 — Wide black dual cord-access hatch

Black keyed hatch with dual 30/50A power-cord pass-through access.

View 94317 product

What to measure and inspect

1. Measure the cutout and outer trim separately, and confirm the 1⅛-inch rear collar clears the wall cavity.
2. Determine whether the compartment needs a normal opening or dedicated smaller cord passages.
3. Match white or black finish and the original keyed or thumb-latch mechanism.
4. Check that the hinge orientation and fastening area are appropriate for your original installation.

Original manufacturer drawings

The B&B Molders official parts catalog (PDF) shows the matching hatch or water-inlet assemblies and factory replacement part numbers on printed pages 44–45. The PDF may open in a separate viewer on mobile.

Need a different footprint? Compare the square large cable-hatch family, which uses an entirely different cutout.