B&B RV Exterior Grab Handles 94164 & 94165: Mounting Guide

A curved grab handle beside an RV entrance provides a handhold when climbing in or out. B&B Molders' 94164 and 94165 use the same contemporary one-piece shape, with hinged screw covers molded into the handle instead of separate loose caps. Choose by the original handle's mounting position, holes and finish.

Choose the correct colour and part number

Mounting and fit measurements

When comparing an existing handle, measure the mounting centres, not just the overall end-to-end length. Check the position of all four screw holes under the hinged covers and make sure the supporting RV structure is sound.

How the one-piece screw covers work

Each molded cover opens to expose the mounting screws, then closes over them for a neat finish. This avoids needing a separate cap for each end. The curved grip and the fastener covers are part of the handle design; the linked products are the complete handle, not a cover-only service part.

White and black product photographs

94164 — Curved RV exterior grab handle — white

View 94164 product

94165 — Curved RV exterior grab handle — black

View 94165 product

Before replacing an exterior grab handle

1. Measure the overall handle and mounting centres on the existing unit.
2. Check the condition of the wall reinforcement and mounting fasteners.
3. Choose the original white or black finish and compare the handle's curve and clearance.
4. Secure and seal the installation following the RV manufacturer's instructions. Do not rely on mounting through unsupported thin skin or trim.

Factory handle illustration

See the B&B Molders illustrated parts catalog (PDF), printed page 62, for the manufacturer's original part-number and component drawings. The PDF may open separately on mobile.